🚀 go-pugleaf

What tends to happen with quarter inch tapes is that to get more data 
onto a tape, successive standards define more tracks on the tape.

As the number of tracks on a tape increase, their width decreases
(after all, its still 1/4 inch  :-)

When it comes to writing a track, the WIDTH of the write head which 
creates the track is (approx) the width of the track. 

Higher capacity drives therefore have narrower write heads than the older
drives (QIC24 -> QIC150 -> QIC320 etc....). 

This means that it is impossible for a "newer" drive to write "wide tracks"
(which the "older" drives can read).                               

It IS possible however for a "newer" drive to READ tapes written with 
wider tracks since the read head fits "inside" tracks (as written by either 
drive). 

It is therefore possible to build a drive which reads/writes a new format 
but can only read older formats. 

It is extreemly difficult (read also: expensive) to try and build a drive 
to read and write all formats. 


-----------------------------------------------------------------
Kevin Jones.                       | Hewlett Packard Ltd,
                                   | Computer Peripherals Bristol,
kev%hpcpbla@hplb.hpl.hp.com        | Filton Road,
                                   | Stoke Gifford,
Tel: 011 44 272 799910 (ext 22351) | Bristol.   BS12 6QZ.
                                   | ENGLAND.
-----------------------------------------------------------------