🚀 go-pugleaf

re: "I was told by a vendor that the Centronix interface in a typical
     (Laserjet II) interface would only transfer data at about 50 Kbaud"

> Is this true, if so is it really worth having a centronix interface in a
> printer?

Yes, if only because the serial interface can only hit about 19.2Kbaud.
Incidentally, both interfaces are always present.

As I understand it, the LJ's I/O performance is limited not by the
interface, but by the architecture.  The LJ was designed back when RAM was
expensive, so it does not have a full page-image buffer.  Each laser scan
line is fabricated in real-time from a tokenized (partially pre-processed)
representation of the input data stream.  The processor is an 8MHz MC68000.
This design is also why Error 21 sometimes occurs.

The print engine will hold-off the interface when the parsing and tokenizing
can't keep up with the inbound data.   This is what limits I/O rates.

Regards,                                              Hewlett-Packard
Bob Niland      rjn%hpfcrjn@hplabs.HP.COM             3404 East Harmony Road
                UUCP: [hplabs|hpfcse]!hpfcla!rjn      Ft Collins CO 80525-9599

This response does not represent the official position of, or statement by,
the Hewlett-Packard Company.  The above data is provided for informational
purposes only.  It is supplied without warranty of any kind.