Canon EP-S cartridge "config" switches?

Thread View: comp.periphs

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by James MacPhail Tue, 29 Dec 1992 00:15

#1218

Author: James MacPhail
Date: Tue, 29 Dec 1992 00:15

18 lines
1210 bytes

Looking for some Canon Laser engine guru...

I have noticed that the Canon EP-S cartridges (used in the LaserWriter II 
etc.) have two "configuration" selector blocks that operate switches in the 
engine. These are rectangular plastic blocks that snap into holes in the 
cartridge. All of the cartridges I have seen have one block installed (the 
one further from the edge).

I'd like to know what the four possible combinations mean. (I hope that one 
might increase the fuser temp so that the toner won't flake off labels so 
easily).

The blocks are located at the end of the cartridge with the levers to open 
the various shutters, and are about 0.25 x 0.5 x 0.38"

Any suggestions?

James MacPhail  jmacphai@cue.bc.ca  james@mirg2.phy.queensu.ca

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads