topsTerm & Mac SE

Article View: comp.protocols.appletalk

Article #5859

Back to comp.protocols.appletalk Previous Next

#5859

From: Eddie Mikell
Date: Fri, 12 May 1989 18:55

27 lines
1424 bytes

I would like to get responses from others on the net regarding their
use of topsTerm - in particular - has anyone successfully ran 
the TCP/IP part with the "configure by hand" option.

I have downloaded the software, unencoded it, unarchived it, placed the
files in the appropriate folders, and rebooted the MAC (an SE with
a Kinetics Etherport SE board - which is running NCSA TN just fine, system
6.02, finder 5.5).

Since I have no KIP gateway, I select the above option, and enter my IP 
address.  This creates the TOPS memory file which is placed in the system
folder.  Anytime I boot the system with this file in the folder, the Mac
crashes with a system error of ID=2.

I have tried this with a "barebones" folder and the results are the same.
I have downloaded the software twice, just in case I got a bad bit somewhere,
but the results are the same.

Any suggestions from other users would be appreciated.  If this is a 
common problem, I'll summarize for the net.


Sincerely,


Eddie H. Mikell
Mississippi State University

Technical Details

Message-ID: <8905121855.AA06455@Wally.CC.MsState.Edu>

Path: arc1-ca.pugleaf.net!utzoo!attcan!uunet!cs.utexas.edu!tut.cis.ohio-state.edu!ucbvax!CC.MSSTATE.EDU!eddie

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!attcan!uunet!cs.utexas.edu!tut.cis.ohio-state.edu!ucbvax!CC.MSSTATE.EDU!eddie
From: eddie@CC.MSSTATE.EDU (Eddie Mikell)
Newsgroups: comp.protocols.appletalk
Subject: topsTerm & Mac SE
Message-ID: <8905121855.AA06455@Wally.CC.MsState.Edu>
Date: 12 May 89 18:55:41 GMT
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The Internet
Lines: 27