🚀 go-pugleaf

Hi,
I've tried to post this before, but either the message didn't make ist
out or nobody answered B-{(

ISO/IEC DIS 10022 describes the "Physical service definition", i.e. the
interface between Layer 1 and Layer 2.
It describes the interface in terms of primitives:
- Activation
- Data Transfer
- Deactivation
One of the activation primitives (Ph-ACTIVATE request) is used to
establish a connection between two PhC endpoints.
When one uses a modem with dialing protocol V.25bis or an X.25
connection, the connection establishment phase uses a different
configuration on the "control lines" while dialing.

Questions:
1. Is this dialing part of ISO layer 1 (physical layer)?
   In my opinion, it is.
2. How do I specify the address/numbers to use?
   DIS 10022 only says that parameters to the activation primitives
   concern the classes of service, but no mentioning of any dialing
   parameters.


--
| Josef Moellers		| c/o Siemens Nixdorf Informatonssysteme AG |
|  USA: mollers.pad@nixdorf.com	| Abt. PXD-S14				    |
| !USA: mollers.pad@nixdorf.de	| Heinz-Nixdorf-Ring			    |
| Phone: (+49) 5251 104662	| D-4790 Paderborn			    |