Thread View: comp.protocols.misc
2 messages
2 total messages
Started by abell
Thu, 10 Aug 1989 14:46
RS-485 to RS-232
Author: abell
Date: Thu, 10 Aug 1989 14:46
Date: Thu, 10 Aug 1989 14:46
10 lines
890 bytes
890 bytes
I was wondering if there is a "black box" which converts RS-485 signals to RS-232 signals for bidirectional traffic? If so, please let me know of any sources for it. Thanks in advance for your help. -- Alan C. Bell (abell@polyslo.calpoly.edu) Computer Science Department ..!ucbvax!voder\ California Polytechnic State University ..!sdcrdcf!csun |!polyslo!abell San Luis Obispo, CA 93407 (805)756-7185 ..!lll-crg!csustan/
Re: RS-485 to RS-232
Author: Marvin Jones
Date: Fri, 11 Aug 1989 18:08
Date: Fri, 11 Aug 1989 18:08
33 lines
1469 bytes
1469 bytes
In article <13373@polyslo.CalPoly.EDU>, abell@polyslo.CalPoly.EDU (abell) writes:
>
> I was wondering if there is a "black box" which converts RS-485 signals
> to RS-232 signals for bidirectional traffic? If so, please let me know
> of any sources for it. Thanks in advance for your help.
>
Try the following:
B & B Electronics
1500 Boyce Memorial Dr.
Ottawa, IL 61350
815-434-0846
or:
Black Box Corp.
Box 12800
Pittsburgh, PA 15241
412-746-5530 .
B & B has less selection, but excellent service and reasonable prices.
Black Box charges way too much, but has a wide variety of protocol conversion
equipment for both hardware AND software protocols.
I have used an RS-422 to RS-232 converter from B & B, and am pleased with it.
Regards,
Marvin Jones
--
Marvin Jones {pyramid, pixar, tekbspa}!optilink!jones
Optilink Corp. ATT-net: 707-795-9444 X 206
1310 C Redwood Way CI$: 71320,3637
Petaluma, CA 94952
Thread Navigation
This is a paginated view of messages in the thread with full content displayed inline.
Messages are displayed in chronological order, with the original post highlighted in green.
Use pagination controls to navigate through all messages in large threads.
Back to All Threads