🚀 go-pugleaf

In article <1992Nov10.182225.14099@porthos.cc.bellcore.com> hand@peabody.bae.bellcore.com (25833- Jim Hand(6379)p102) writes:
>Error: Request encBox:
>  Agent error: agent error 0: cannot find group: "encBox" in
>schema: "ciscoMmib" or default schema: "snmp-mibII"
>
>	Does anyone have any idea what I might be doing wrong?  Thanks
>in advance.

Hello Jim,

   This question should most likely be addressed with SunConnect, but
I'll be willing to give it my best shot.  1) SNM 1.2 uses a file
called /var/adm/anm/snmp.hosts.  This file may not be needed anymore
if you can query the proxy host directly.  I would check to make sure
that the default schema in this file for the host you are setting up a
Data Report is correct.  Ideally, if you can, remove this file as SNM
2.0 does not need it anymore.  2) Make sure that the Property sheet
for the device you are setting up the Data Report for has all the
appropriate schemas checked.  Let's say that the group encBox exists
in the enc MIB.  Make sure you have the enc box checked on the device
you are trying to query.

   If you still cannot figure out your problem, I would contact SunConnect
directly.  By the way, I think there is a SNM users mailing list
somewhere for these types of issues (again, ask Sun :-).

Thanks,

Allan Leinwand
cisco Systems
(415) 688-7653
leinwand@cisco.com