🚀 go-pugleaf

In article <1993Jan15.142317.2091@msus1.msus.edu> mndot@msus1.msus.edu writes:
>In article <1j72f7INN5pj@gaia.ucs.orst.edu>, leach@OCE.ORST.EDU (Tom Leach) writes:
>> I've just received a couple of CableTron MiniMMACS with the SNMP board
>> installed (the NCMM board).  When I fire up snmpwalk (cmu snmp V1.1b) or
>> SunNet Manager (V1.2 or 2.0), they all report just 1 interface.
>I believe this is the correct response.  Their is truely only one interface. 
>It is either the AUI connector or the Fiber connector to your backbone.  I
>could be wrong on this but it seems to be consistent with the rest of
>cabletron's equipment and how they report.

Or, if that is not the answer, perhaps your box doesn't have all ports
enabled. I've often been tricked by the fact that you have to enable
new ports from the terminal port when installing new cards in the MMAC.

/Per


-- 
-----------------------------------------------------------------------------
Per Andersson - ppan@nobeltech.se (perand@stacken.kth.se on free time)
Managing networks at, but not speaking for Nobeltech AB, J{rf{lla, Sweden
-----------------------------------------------------------------------------