Desktop NC Mills

Thread View: comp.robotics

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Ken Goldberg Fri, 29 Jan 1993 01:52

#1911

Author: Ken Goldberg
Date: Fri, 29 Jan 1993 01:52

10 lines
852 bytes

Is it possible to buy a small-scale (desktop) 4-axis milling machine
that has an NC interface (preferably RS-232)?  The XY travel requirement
is about 10x10 cm^2, and the Z axis should travel at least 3cm.  The
precision does not have to be very high;  .01 inch would be acceptable.
I'll post any leads that I get to this group.

-- 
Ken Goldberg | goldberg@usc.edu | (213) 740-9080 | 208 Powell Hall,  USC
Asst. Prof of Computer Science and EE-Systems    | LA, CA 90089-0273 USA

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads