🚀 go-pugleaf

In article <4844006877fruit@argonet.co.uk>,
 Andy Carter <fruit@argonet.co.uk> wrote:
> In article <4843fd9fb3fillin@argonet.co.uk>,
>  Phil/Lin Spiegelhalter <fillin@argonet.co.uk> wrote:
> > So I've tried to use Connect/Mail
> I shouldn't bother :-)
> > (There appears to be no PORT selection for the Modem

Thanks to Andrew for pointing out that the option is there by editing the
run file! (and also for his config text which I had printed out earlier to
confirm my argo setup for connecting) 
(Shame not mentioned in the manual 8-))
> ..have a look in !Connect.!Run, you should see the following...
>  | Check for internal modem, defaulting to serial port if not found.
>  |
>  Set Connect$blockdriver IntModem
>  RMEnsure UARTDeviceDriver 0.20 Set Connect$blockdriver InternalPC
>  |
>  Set Connect$blockport 0
> Try changing InternalPC to the appropriate SP_Dual driver in
> !SerialDev.Modules, and Connect$blockport 0 to whatever your port number
> is.
> Andy
Phil: Thanks - that worked - now I understand your previous comment...
   of "why bother"
It logged on and then off in 1 second (0 really) with no messages - so I
don't know if any of it was actually successful.
(But this was without rebooting since using Voyager)

Phil

-- 
Phil and Lin Spiegelhalter - Fillin   http://www.argonet.co.uk/users/fillin
Acorn RiscPC+StrongArm  Videodesk, Photodesk, Cluttered desk...