🚀 go-pugleaf

In article <5847@krafla.rhi.hi.is> adamd@rhi.hi.is (Adam David) writes:
>blekken@fwi.uva.nl (Erwin 'Yaaah' Blekkenhorst (I88)) writes:
>
>>I have a Lingenuity SCSI interface (shouldn't have bought it in the first
>ace)
>
>I have the same problem as far as this goes. Will there ever be a firmware
>upgrade?
>
I don't know if Lindis will ever support an firmware upgrade but
someone with an EPROM-programmer might help you with it. Lindis
usually supplies an ROM-image on their support disks.

>Unless subsequent damage has occured, wiping and reconfiguring the CMOS
>values should fix it. If it is very old Lingenuity firmware, they might
>have made a mistake that has since been fixed. I think I'm running the
>1.3 firmware. Apart from the obvious hassles with directory size and filename
>length, the only noticeable omission is that the new method of showing the
>disk free-space is not supported. And of course the old gripe that it is

The latest version I know about is the 2.43 or the like; it runs well on
my old (1.2? or 1.30) hardware. Versions 1.87 is a stable version
that ran well.

The free-space "problem" may be fixed by an alias:
set alias$free showfree -fs SCSI %*0
{this should be refined by testing on command mode or using
<FS$temporaryFS> }

Success
-- 
--- Peter W. Roozemaal --- Email: witaroo@dutinfh.twi.tudelft.nl --------------
-------------------------- Smail: Geitenkamp 45 -------------------------------
--- tel. +31-15-611389 ---------- 2623 BB  Delft ---------- If it's urgent, ---
--------------------------------- the Netherlands --------- don't phone me! ---