Problem printing directly to LaserJet+

Thread View: comp.sys.acorn.tech

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Kjetil Bernhard Thomassen Tue, 24 Nov 1992 03:27

#594

Author: Kjetil Bernhard Thomassen
Date: Tue, 24 Nov 1992 03:27

23 lines
1496 bytes

I've got my 4 MB A310 running RiscOS 3.10 connected to a Facit P7150
laser printer via the parallell port. This printer emulates the HP
LaserJet+ and has 2,5 MB of RAM. 

My problem is the following: When I print a document from Draw using
the HP LaserJet II driver in 300x300 dpi resolution directly to the
printer, the output is distributed over several pages.  This does not
happen if I print the document to file and therafter dump this file to
the printer. If I print the document in 150x150 dpi, everything works
fine. What is going on?

I also had the same problems using PrinterLJ 2.42 and 1.xx running
RiscOS 2.00. Is this a problem with my printer, my computer or RiscOS?

I think my printer is using CR+LF or LF+CR as line terminator.
This is configurable, but I haven't tested other configurations. I
have configured my A310 to 'no ignore'.

I now have MEMC1a, but with RiscOS 2.00 I had the original MEMC1.

Kjetil Bernhard Thomassen
bernhard@pvv.unit.no (This address is opposite janet addresses, no
                      means Norway.)

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads