🚀 go-pugleaf

ejack@user1.channel1.com (Eric D. Jackson) writes:


>>In a message from 27-Feb-96 23:10:14, Valiant wrote:

>>>When using the Installer to setup the AmiTCP 4.0 demo, it gives me a DOS
>>>error 'can't find drawer or file' when it asks if I want to add the user.
>>>What am I missing?

>>If you have choosen "pretend to install" (which I assume) at the beginning of
>>the install procedure this error occures because the drawer where the
>>password-file is stored doesn't exist. Otherwise I don't have a clue except
>>that maybe your install-file is damaged somehow.

>Did you test the archive or try downloading it again? Maybe you have a
>defective archive.

Thanks for all the helpful advice.  Choosing "install for real" took 
care of the problem and I was able to configure AmiTCP.  However, now 
when I run the script to connect to my local ISP, I get a requestor from 
AmiTCP:bin/ifconfig that says 'AmiTCP/IP version 4 or later must be 
started first'.  The window for AmiTCP does open first, but I have to 
wait about a minute before I can click on the OK button and proceed.  Do 
I need to register AmiTCP 4.0 in order to bypass the window and allow 
ifconfig to work correctly?  Thanks in advance for any suggestions...

Val Marti
vmarti@xmission.com