🚀 go-pugleaf

Hi all,

I also have problems with AWeb v1.0 (I have sent all of the info
to Yvon already, but I want to see if others are having the 
same problem - I sent him also some Enforcer hits I was able to
capture!).  The problem I experienced, and it is something that
happens ALL of the times, in other words, I can make it happen
every single time I run it, is that when I exit/quit AWeb, while
running on an (registered) CyberGraphX v2.16 800x600x16-bit screen
using the 24-bit picture.datatype v43.668, I ALWAYS, ALWAYS, w/o
failure, get a System Crash #80000008 - this is w/o failure!  It
runs flawlessly, however, while it is running - it is FAST and it
looks GREAT w/24bit DT; just AWESOME!

If I run AWeb either on my cgfx 800x600x256 WB screen or on its
own cgfx 800x600x256 screen, it works fine - no problems when
exiting/quitting!  

I have also removed my WBStartup drawer and the only thing I have in
my Startup-Sequence is PrepreEmul (for ShapeShifter's use), and the
only thing that I have in my User-Startup are assigns, paths, setenv's
and the AmiTCP assign stuff and the MUI assign stuff and that is it!
No hacks except for CyberGraphX and the 24-bit picture.datatype!

Anyway, just want to hear from anyone that may have similar problems!
My system is: A3000@25, 16 Meg FAST, 2 Meg CHIP, Picasso-II 
w/registered CyberGraphX v2.16, AmiTCP, WB40.42/KS40.68.  Ok, that is
it!