🚀 go-pugleaf

Hi All,

Have been using SLIPCall4 Version 37.51 for some time now with my Maestro
9600XR modem and have had no problems connecting at 2400 to my service
provider.

I recently purchased a MULTITECH 28.8 modem and have not been able to connect
with my service provider since. I am using the modem's default string of ATF\r
as my initialising string. The modem connects with my server usually at 26800.
It then sends login name and password, says "starting AmiTCP" and the modem
then goes offline.

The display shows IP as 0.0.0.0, name: localhost, connected to Merlin etc. I
have included an AmiTCP output as follows

<sb>

S2_ONLINE: Device driver is offline (Unit is currently offline)
AmiTCP:bin/online failed returncode 10
Login incorrect
login:
AmiTCP:Bin/login failed returncode 10
add net 0.0.0.0: gateway localhost
add net default: gateway 0.0.0.0: Object exists
[CLI 2]

<sb>

My setup is as follows: AmiTCP Version 4.1, PPP Version 1.45 unregistered.
Serial device is v34serial.device. Workbench serial preferences are set at
31250 baun, RTS/CTS, 8N1.

The only changes made to the setup when changing to the new modem was serial
rate set at 57600. When this did not work, all rates were set and various
other initialisation strings were tried all with the same results.

The modem works fine with GPFAX and TERM 4.5.

I hope this information will assist you in determining the problem I am having
and look forward to hearing of any suggestions you may have.

CIAO


Trevor Daley

<tsb> AMIGA A1200/030/40Mhz - 2meg Chip / 16meg Fast Ram - 1.08Gig HD

                                  *
         Trevor Daley                   E-Mail:- tldaley@merlin.net.au
         57c Seacombe Road      *   *   FidoNet:- Trevor Daley@3:800/443
         Seacombe Gardens         *     Phone:- +61 8 377-2940
         South Australia 5047           Mobile Phone:- 0419 814 732 (Aust)
         Australia               *

<tsb> Live Long And Prosper

Idiots do have a redeemable feature - mortality.