🚀 go-pugleaf

In article <585@ssp15.idca.tds.philips.nl> fwvo@idca.tds.PHILIPS.nl (Ferdinand van Ommen) writes:
>When attaching a dumb vt100-terminal to the Amiga-500's serial port I
>succeeded in starting up the communication.(I started newcli ser:).
>However, the following problem arose:
>If you want a command to be executed it seems to be necessary to fill 
>the serial port's buffer (which has a minimum of 1/2kilobytes according to
>'preferences') with newlines.
That is not the serial buffer that must be filled but the CLI's command line buffer.

>I expect a new driver will be needed for full interactive use.
>Question is: is there a way to use the standard driver for the communication
>or will a quite differing one be needed.
The standard driver will pass READ requests to the serial.device. So if you
READ a buffer of 512 bytes the request returns if the serial.device has copied
512 bytes into your buffer. You have to abort reading if a linefeed is found
in the serial.device input stream. SER: doesn't use this.
Also, serial.device doesn't know anything about command-line editing and
BREAK signals (CTRL-C to CTRL-F).

>Second question then is: Does anyone have a better one, or do you know where to
>get it?
Yes, there is a PD handler you can find on a Fishdisk. I don't know the number,
but I tested it.
Metacomco sells one with there Toolkit.
WB 1.3 has a handler that can be used. I don't have this one but it should be
available now.

				Michael van Elst

E-mail: UUCP: ...uunet!unido!fauern!faui44!mlelstv