MicroBotics SCSI woes

Article View: comp.sys.amiga.tech

Article #11790

Back to comp.sys.amiga.tech Previous Next

#11790

From: Jim Hutchison
Date: Tue, 14 Mar 1989 06:21

10 lines
868 bytes

I recently became the owner of a MicroBotics SCSI module.  What it is
is a NEC SCSI chip and some support.  Where the problem comes in is
talking to the device.  MicroBotics does not include any suggestions
on how to send SCSI commands to the device driver so that you can send
setup commands to the SCSI device on the other end (an OMTI controller).

Does anyone out there have any suggestions?  Is it time to attempt to
disassemble the device driver?

/*    Jim Hutchison   		{dcdwest,ucbvax}!cs!net1!hutch  */

Technical Details

Message-ID: <1524@ucsd.EDU>

Path: arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!ucbvax!ucsd!net1!hutch

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!ucbvax!ucsd!net1!hutch
From: hutch@net1.ucsd.edu (Jim Hutchison)
Newsgroups: comp.sys.amiga.tech
Subject: MicroBotics SCSI woes
Message-ID: <1524@ucsd.EDU>
Date: 14 Mar 89 06:21:25 GMT
Sender: nobody@ucsd.EDU
Reply-To: hutch@net1.UUCP (Jim Hutchison)
Lines: 10