🚀 go-pugleaf

Aaron Avery said:
>Actually, the serial.device fails dependent on DSR, and pretty much ignores
>CD. You can always find out CDs status via the QUERY command.

  I knew about Query. I query every time I get a packet back. DSR interests
me. I checked my modem manual, and yes, I can make "DSR is ON only
when a carrier is detected from the remote modem."
  How do I send _commands_ to the modem. (It is easy, until
I turn DSR control on.. I could do that when I dial, but then
when I lose the carrier I'd have to reset the modem with DTR
before I could send to the modem...)

>Yes, ASDG provided an additional command which gives you control over the
>status of the output pins DTR and RTS.

  Beautiful. Now where was that paycheck.. Hmm, next week I guess.

>ASDG's SER: and AUX: type handlers provide this type of command-line
>parameter setting. Plus, there are defaults for each Mountlist entry above
  Details?

>the preferences settings. They do not support some of the packets associated
>with 'dir', as it makes no sense under the current Commodore specification.
  I didn't expect that yet. :-)

>Aaron Avery, ASDG Inc.         "A mime is a terrible thing to waste."
>                                                             -- Robin Williams

--

  :!mcr!:
  Michael Richardson                     Amiga
                                  v--------+
 UUCP: uunet!attcan!lsuc!nrcaer!julie!mcr  | INTERNET mcr@doe.carleton.ca
 Fido: Michael Richardson @ 1:163/109.10<--+ Alter @ 7:483/109.10