Article View: comp.sys.amiga.tech
Article #2678Re: Help with Execute()
From: Fred Fish
Date: Mon, 11 Dec 1989 16:22
Date: Mon, 11 Dec 1989 16:22
21 lines
1059 bytes
1059 bytes
In article <855@wet.UUCP> mcw@wet.UUCP (Martin Warnett) writes:
>Question: Is there any way I can set the stack size for the executed
>program from within my program?
The only way I found when using Execute() to get control of the
subprocess's stack size is to tack a stack command onto the front
of whatever string you were passing to Execute(). I.E., if your
execute command was:
"ram:doit arg1 arg2"
pass it
"stack 123456\nram:doit arg1 arg2"
instead (note the embedded newline character).
-Fred
--
# Fred Fish, 1835 E. Belmont Drive, Tempe, AZ 85284, USA
# 1-602-491-0048 asuvax!{nud,mcdphx}!estinc!fnf
Technical Details
Message-ID:
<243@estinc.UUCP>Path:
arc1-ca.pugleaf.net!utzoo!attcan!utgpu!jarvis.csri.toronto.edu!clyde.concordia.ca!uunet!cs.utexas.edu!asuvax!mcdphx!estinc!fnfReferences:
<855@wet.UUCP>Show Full Headers
Complete Article Headers
Path: arc1-ca.pugleaf.net!utzoo!attcan!utgpu!jarvis.csri.toronto.edu!clyde.concordia.ca!uunet!cs.utexas.edu!asuvax!mcdphx!estinc!fnf From: fnf@estinc.UUCP (Fred Fish) Newsgroups: comp.sys.amiga.tech Subject: Re: Help with Execute() Message-ID: <243@estinc.UUCP> Date: 11 Dec 89 16:22:32 GMT References: <855@wet.UUCP> Reply-To: fnf@estinc.UUCP (Fred Fish) Organization: Enhanced Software Technologies, Inc. Lines: 21