🚀 go-pugleaf

In article <1363@lpami.wimsey.bc.ca>, lphillips@lpami.wimsey.bc.ca (Larry Phillips) writes:
> In <28681@cup.portal.com>, phorgan@cup.portal.com (Patrick John Horgan) writes:
> >Just wanted to add a note to anyone doing scsi direct for tapes.
> >The 2090A doesn't seem to support multi-block read/writes.  If you
> >always do a 1 block read/write it's ok, otherwise you get phase-errors.

    I have had success with the 2090 with another tape drive doing
multi reads and writes. My hddisk.device came from the 2090A diskette 
which is the latest version I could find for the 2090. I had nothing but
problems until I got hold of this.

> Thanks for the tip. I'll check that out. I haven't been getting phase errors,
> unless the hanging in DoIO is actually due to a phase error that is not being
> reported (I know the error reporting of hddisk.device is hosed). It's sure
> worth a shot though.

    The tape drive I'm trying to run now does a lot of what Larry is describing.
My suspicion is the tape drive, since this has worked for me before.

    What tape drive are you using Larry?

> +-----------------------------------------------------------------------+ 
> |   //   Larry Phillips                                                 |
> | \X/    lphillips@lpami.wimsey.bc.ca -or- uunet!van-bc!lpami!lphillips |
> |        COMPUSERVE: 76703,4322  -or-  76703.4322@compuserve.com        |
> +-----------------------------------------------------------------------+
-- 
Harald Milne                   RISCy business	       uunet!ccicpg!boink!harald