Help! Installed RAM on 2091, Sculpt 4D crashes

Article View: comp.sys.amiga.tech

Article #3550

Back to comp.sys.amiga.tech Previous Next

#3550

From: Marilyn Martin
Date: Wed, 09 May 1990 15:40

14 lines
869 bytes

I just installed 2M on my 2091 card.  Used mergemem to address it. Shows
up on status line in Workbench and status line in Sculpt 4D. BUT when
Sculpt tries to access RAM over standard 3M (2500/30) IT CRASHES!  Avail
shows RAM as being there.  But Ramtest (whatever the name of that utility is
that comes with Workbench 1.3) says BAD BIT at all the addresses.

Help!

Signed, megadespair

Marilyn Martin
NMSU Computer Center
LAs Cruces NM 88003
505-646-1840 (for those of you with a watts line)

Technical Details

Message-ID: <619@opus.NMSU.EDU>

Path: arc1-ca.pugleaf.net!utzoo!utgpu!news-server.csri.toronto.edu!mailrus!umich!yale!cmcl2!lanl!opus!dante!mmartin

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!utgpu!news-server.csri.toronto.edu!mailrus!umich!yale!cmcl2!lanl!opus!dante!mmartin
From: mmartin@nmsu.edu (Marilyn Martin )
Newsgroups: comp.sys.amiga.tech
Subject: Help! Installed RAM on 2091, Sculpt 4D crashes
Keywords: RAM
Message-ID: <619@opus.NMSU.EDU>
Date: 9 May 90 15:40:10 GMT
Sender: news@nmsu.edu
Distribution: usa
Lines: 14