🚀 go-pugleaf

In article <1990Jul28.175504.8763@csmil.umich.edu> chymes@fribourg.csmil.umich.edu (Charles Hymes) writes:
>I am trying to figure out what is going on with the boot code of
>several programs, including the standard AmigaDos bootblock.
>I need to know:
> (A) Exactly what byte does the code start running at? The RKM 1.3 says
>	"location 12" but is that in decimal or Hex? Some code seems to
>	alreald have run some stuff before the code at 12, decimal starts.
>	Also, what is in that word after the bootblock checksum?

The RKM also refers to devs/bootblock.h, which says:
	struct BootBlock {
		UBYTE bb_id[4];	   /* 'D','O','S','\0' or 'D','O','S','\1' */
		LONG  bb_chksum;   /* checksum */
		LONG  bb_dosblock; /* reserved for DOS patch */
	}  /* These are bytes 0-11, execution starts with byte 12 (decimal) */

> (B) What do the 68k registers contain when the boot block code is loaded
>	and run? Especially the Address registers, Particulary A6.

A1 points to an I/O request to the trackdisk.device, no other registers are
specified in the RKM.  Because the the code returns, A7 can be assumed to
be a valid stack pointer.  Don't know about A6.

> (C) Where is the bootblock loaded into? The RKM 1.3 manual says that
>	it is arbitrary, but two of the first lines in the boot code on
>	one autobooting disk are:
>		PHA $10?? ( I dont remember these two addresses)
>		PHA $2???

PHA is an opcode for a 6502 processor (Commodore-64), not a 68000 (Amiga).
Looks like you're using the wrong disassembler.  The 68000 does handle
position independent code.
-- 
Joe Smith (408)922-6220 | SMTP: jms@tardis.tymnet.com or jms@gemini.tymnet.com
BT Tymnet Tech Services | UUCP: ...!{ames,pyramid}!oliveb!tymix!tardis!jms
PO Box 49019, MS-C41    | BIX: smithjoe | 12 PDP-10s still running! "POPJ P,"
San Jose, CA 95161-9019 | humorous dislaimer: "My Amiga speaks for me."