Removing 1.3 partition on A3000

Article View: comp.sys.amiga.tech

Article #5800

Back to comp.sys.amiga.tech Previous Next

#5800

From: Skank George L
Date: Sat, 13 Oct 1990 05:17

8 lines
976 bytes

  Hello again folks!  Does anyone out there know if it is possible to reformat
the hard drive on the A3000 so that it contains ONLY a Workbench 2.0 partition,
rather than both 1.3 and 2.0 partitions?  It is my intention to run only
software that runs correctly under 2.0 and I'd like to have the disk space that
the 1.3 partition is taking up.  Thanks,

                                     --George

Technical Details

Message-ID: <1990Oct13.051751.6532@news.iastate.edu>

Path:

arc1-ca.pugleaf.net!utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!uunet!dino!news.iastate.edu!du248-09.cc.iastate.edu!skank

References: <1990Oct12.221930.4281@news.iastate.edu>

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!uunet!dino!news.iastate.edu!du248-09.cc.iastate.edu!skank
From: skank@du248-09.cc.iastate.edu (Skank George L)
Newsgroups: comp.sys.amiga.tech
Subject: Removing 1.3 partition on A3000
Keywords: 1.3, 2.0, Hard Disk
Message-ID: <1990Oct13.051751.6532@news.iastate.edu>
Date: 13 Oct 90 05:17:51 GMT
References: <1990Oct12.221930.4281@news.iastate.edu>
Sender: usenet@news.iastate.edu (USENET News Poster)
Reply-To: skank@iastate.edu (Skank George L)
Organization: Iowa State University
Lines: 8

Reply to Parent Message