🚀 go-pugleaf

In article <2218@lpami.wimsey.bc.ca>, lphillips@lpami.wimsey.bc.ca (Larry Phillips) writes:
> In <45608@eerie.acsu.Buffalo.EDU>, v089pfrb@ubvmsb.cc.buffalo.edu (Jeffrey C Murphy) writes:
> >Does any know where I might find some empty circuit boards that will 
> >fit into the A2000's 100 pin slot and also some that will fit into the
> >CPU slot? If so what is the cost per board?
> 
> I got one from NES in Oregon (Bill Seymour should be able to give you the
> address.. I can't find it). It is a Zorro board with connectors for the IBM
> slots as well. It cost me about $50.
> 
> -larry

    Does anyone manufacture one of these with built-in autoconfig and 
decode logic?  I used to have one of these (on an older computer) that 
made prototyping a breeze - just use the existing decode and interface
logic, and plug in your new stuff.  

    On the other hand, how do you build an autoconfig block?  I've read
the A2000/A500 technical reference manual discussion on this, but I
don't have a PAL burner.  They give equations for these suckers, which
leaves me out in the cold.  I suppose I could look at the equations and
figure out just what is going on, but I don't have that much time.

    Ideas, comments?

     Dave Williams
        dawill@hubcap.cmemson.edu
           "Huh?  What?  Could you repeat the question?"