🚀 go-pugleaf

mrush@ecst.csuchico.edu (Matt "C P." Rush) writes:

>In article <1990Nov25.093445.10710@evax.arl.utexas.edu> hill@evax.arl.utexas.edu (Adam Hill) writes:

>>Don't EVER fill a CBM hd >95% full.. Why? He did not go in depth.

>	When this thing gets anywhere over 97% full, I start getting "Volume
>Overdrive has a Read/Write Error...." messages just from trying to READ a file
>(using 'more', or 'type').

It sounds to me like you've told the system that the hard drive is a
little bigger than it actually is. I've had no problem at all when one of
my 70 meg partitions was 100% full, either on the Hardframe on the
2000/2500 or on the A3000 controller.

For a simple test of your drive, get Fred Fish's FillDisk program (on
one of the older disks), and run it on your hard drive. FillDisk simply
opens a file, and starts writing to it until the disk fills up. Fred
intended it to clobber any deleted files that you might not want someone
else undeleting, but it does make a handy disk tester.

If FillDisk starts reporting I/O errors at 97% full, I'd suggest backing
up your drive, reformatting it with a few fewer cylinders, and running
FillDisk again. If you get no errors the second time, you've found the
problem.

This worked fine for me when I wanted to verify that the fake floppies
I'd created by juggling mountlist entries did not overlap any other
partitions.
-- 
Blaine Gardner @ Evans & Sutherland  580 Arapeen Drive, SLC, Utah 84108
blgardne@esunix.UUCP                       BIX: blaine_g
{decwrl, utah-cs}!esunix!blgardne          PLink: BlaineG
DoD #0046                          My other motorcycle is a Quadracer.