🚀 go-pugleaf

In article <11738@hubcap.clemson.edu> dawill@hubcap.clemson.edu (david williams) writes:
:In article <2218@lpami.wimsey.bc.ca>, lphillips@lpami.wimsey.bc.ca (Larry Phillips) writes:
:: In <45608@eerie.acsu.Buffalo.EDU>, v089pfrb@ubvmsb.cc.buffalo.edu (Jeffrey C Murphy) writes:
:: >Does any know where I might find some empty circuit boards that will 
:: >fit into the A2000's 100 pin slot and also some that will fit into the
:: >CPU slot? If so what is the cost per board?
:: 
:: I got one from NES in Oregon (Bill Seymour should be able to give you the
:: address.. I can't find it). It is a Zorro board with connectors for the IBM
:: slots as well. It cost me about $50.
:: 
:: -larry
:
:    Does anyone manufacture one of these with built-in autoconfig and 
:decode logic?  I used to have one of these (on an older computer) that 
:made prototyping a breeze - just use the existing decode and interface
:logic, and plug in your new stuff.  

	There was a company that made one with one type of autoconfig
design on the board, but I don't know if they're still available or not.

:    On the other hand, how do you build an autoconfig block?  I've read
:the A2000/A500 technical reference manual discussion on this, but I
:don't have a PAL burner.  They give equations for these suckers, which
:leaves me out in the cold.  I suppose I could look at the equations and
:figure out just what is going on, but I don't have that much time.

	You can always substitute a PROM for the PAL. Autoconfig is just
a set of address reads followed by a write. You still have to do the
521/374 thing, but the bulk of the PAL stuff could be put in a small
EPROM easily enough. A PAL is just cheaper... And on our designs, we've
tended to put pretty much the whole thing into a bigger PAL. That's the
main problem I've had with doing a board with autoconfig hardwired in,
you still have to burn a PAL or PROM, and you're much more limited on
what else you can do with that part. I hate to waste any PAL functionality
just because I needed part of it for the autoconfig. :-)

:    Ideas, comments?
:
:     Dave Williams
:        dawill@hubcap.cmemson.edu
:           "Huh?  What?  Could you repeat the question?"

-- 
     -Bill Seymour                                            billsey@agora
***** American People/Link Amiga Zone Hardware Specialist  NES*BILL *****
Bejed, Inc.       NES, Inc.        Northwest Amiga Group    At Home Sometimes
(503) 281-8153    (503) 246-9311   (503) 656-7393 BBS       (503) 640-0842