Using the amiga from the serial port

Article View: comp.sys.amiga.tech

Article #7342

Back to comp.sys.amiga.tech Previous Next

#7342

From: Andy Colebourne
Date: Mon, 10 Dec 1990 12:31

23 lines
1249 bytes

I am writing a program to  enable an amiga to be used from the serial
port.  The serial port will accept cli commands and the output of these
commands will be sent to the serial port.

Can 'Execute' be used to send the output of the command to the serial.device?

(if I do "Execute("dir >ser:", 0, 0)" the command cannot open the serial device
because it is open for receiving the commands.)

It should be possible to execute a command, redirecting the output to a file
in RAM:, the reading the file and sending this to the serial port - but I'm 
hoping that there is a more elegant way of doing it.

It would be nice to control a shell so that all the functions like aliasing 
could be used.

Any help/code/suggestions would be very welcome!!

Thanks!

Andy

andy@uk.ac.lancs.comp

Technical Details

Message-ID: <1132@dcl-vitus.comp.lancs.ac.uk>

Path:

arc1-ca.pugleaf.net!utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!usc!wuarchive!uunet!mcsun!ukc!edcastle!dcl-cs!andy

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!usc!wuarchive!uunet!mcsun!ukc!edcastle!dcl-cs!andy
From: andy@comp.lancs.ac.uk (Andy Colebourne)
Newsgroups: comp.sys.amiga.tech
Subject: Using the amiga from the serial port
Message-ID: <1132@dcl-vitus.comp.lancs.ac.uk>
Date: 10 Dec 90 12:31:57 GMT
Reply-To: andy@dcl-cs.UUCP (Andy Colebourne)
Organization: Department of Computing at Lancaster University, UK.
Lines: 23