🚀 go-pugleaf

In article <scot.5138@amigash.UUCP> scot@amigash.UUCP (Scot L. Harris) writes:
>                                                              The only
>compatibility type problem I have with serial ports is with the JX-100
>ScanLab software.  It insists on banging on the default port before hitting
>the internal port directly.  As a result I have to set the default port back
>to unit 1 before I use the JX-100.  I had hoped that ASDG could provide me
>with a patch or update or something that would let the ScanLab software either
>pick the unit number it is to use or at least make it look for unit 1 instead
>of unit 0 (the default port).

This brings up another interesting question: Does the Scanlab software
know about ASDG's Dual serial port board? I have Scanlab and the JX-100
but I've seen no explicit mention of it in the manual (probably because
I haven't read it). Would it recognise the the "amiga serial port" on
the board and operate it at full speed without problems?

Jesper.
-- 
------------------------------------------------------------------------------
USEnet: jep@mtiame.mtia.oz.au            UUCP: ...!uunet!munnari!mtiame.oz!jep
[...] I had to leave out reality to keep the post clean and to the point.
            - jeremy@milton.u.washington.edu (Jeremy York) in rec.music.misc