🚀 go-pugleaf

>device). I hooked up my terminal and it worked! I just happened to
>set the terminal to the correct parameters (9600 baud, 8 data bits,
>no parity). There was no indication in the AmigaDos 1.3 supplements
>to indicate that this was the set up. 

>[1] Is there any way to adjust the serial parameters (ie: higher 
>baud rate, parity changes, etc)? I am assuming not.

Use Pefences (sic) to set up the serial paramters.
But to get them To work i think ya must reboot...
unless ya change them BEFOR ya mount AUX:


>[2] I tried running Manx's VI-like editor Z and got a software 
>error: I am assuming that Z wont work properly from an AUX:

there are 2+ VI clones out, Stevi, and another..

There's an EMACS clone on FF354 (Or close) with source.. It 
SHOULD be able to work over AUX:

It didsn't work as it was compiled on disk tho)
(With AUX: that is..)


>[3] Are there any alternate PD device handlers I could mount and 
>use to replace AUX: that would handle a terminal as I want? (Again, 
>if you mailed me the source code...)

No idea, one with a Termcap option would be nice tho.
--
yorkw@ecn.purdue.edu  Willis F York says:   
 IF ya meat an Amiga Owner that says: "I got my amiga Just to play games...:
there's only one thing to do...
Give him a Boot to the head... Then repeat .... Then repeat...