Is is possible to engineer out the WCS board on an A1000?

Article View: comp.sys.amiga.tech

Article #9800

Back to comp.sys.amiga.tech Previous Next

#9800

From: Ethan R. Dicks
Date: Thu, 15 Sep 1988 02:07

19 lines
1177 bytes

Assuming I _want_ to hack up my A1000, is there a way to fully remove the
daughter card and re-install the original logic?  I would like to install PALs
and TTL logic where the daughter card extender posts go (like the silk screen
says), and then get some ROMs.  I would assume that the only ROMS for the
A1000 are for very old versions of KickStart (like 29 or 30), so this project
might not be viable.

Thanks in advance,
-ethan




-- 
Ethan R. Dicks       | ######  This signifies that the poster is a member in
Software Results Corp|   ##    good sitting of Inertia House: Bodies at rest.
2887 Silver Drive    |   ##
Columbus OH    43211 | ######  "You get it, you're closer.

Technical Details

Message-ID: <21811@tut.cis.ohio-state.edu>

Path: arc1-ca.pugleaf.net!utzoo!utgpu!water!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!erd

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!utgpu!water!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!erd
From: erd@tut.cis.ohio-state.edu (Ethan R. Dicks)
Newsgroups: comp.sys.amiga.tech
Subject: Is is possible to engineer out the WCS board on an A1000?
Keywords: .hardware A1000 Daughter card no-more-kickstart
Message-ID: <21811@tut.cis.ohio-state.edu>
Date: 15 Sep 88 02:07:35 GMT
Distribution: na
Organization: The Ohio State University Dept of Computer and Information Science
Lines: 19