Assempro Quirk

Thread View: comp.sys.amiga.tech

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Jeffrey C Murphy Fri, 14 Dec 1990 07:23

#7447

Author: Jeffrey C Murphy
Date: Fri, 14 Dec 1990 07:23

11 lines
1085 bytes

 While fiddling around with Assempro's Debugger,I decided to list memory
starting as SSP (which was $c80000).I figured that being that memory was
only being read, nothing should happen. Well, when I first listed the
block, the monitor screen flicked, as if the video source was being inter-
upted. So? Probably as short power interruption. Then I tried to switch from
a disassembled listing to a hex dump and... blank, blink, blink... guru.
I rebooted and tried it again and got the exact same results. Just out of
curiousity: Does anyone know why this happens?

Jeff M. v089pfrb@ubvmsd.bitnet

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads