ARexx and DigiPaint3

Thread View: comp.sys.amiga.tech

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Jonathon Sivier Tue, 18 Dec 1990 16:37

#7523

Author: Jonathon Sivier
Date: Tue, 18 Dec 1990 16:37

25 lines
1492 bytes

Dear NetLanders,
   I am attempting to control Digipaint 3 with ARexx.  Has anyone had any
experience in doing this.  I am trying to get it to print the picture which is
currently being displayed.  I am using the following code to try and do this.

address 'DigiPaint' 'Prin'
address 'DigiPaint' 'Pcok'

   This should bring up the print requester and then tell DigiPaint that it is
OK to print.  At first I tried just the Pcok command, but that didn't work
either.  DigiPaint seems to be getting the message and I get no error messages,
but no printing takes place.

   Is there something else I need to do before printing?  If anyone has any
insights into this I would like to hear them.

Thanks
Jonathan Sivier

-------------------------------------------------------------------
|  Jonathan Sivier               |  Ballo ergo sum.               |
|  jsivier@ux1.cso.uiuc.edu      |  (I dance therefore I am.)     |
|  Flight Simulation Lab         |	        - des Cartwright  |
|  Beckman Institute, Urbana IL  |                                |
-------------------------------------------------------------------

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads