🚀 go-pugleaf

I have heard reports that Ditto II is supposed to allow printing to the
SLM804 laser. I hope this is true. I use a '286/'287 PC at work and it is
a real pain waiting 10 to 20 minutes for detail graphics to print out on
an HP laserjet via the parallel port. The same GEM pic that took l{14 min 55 sec
on the PC took only 45 seconds from a Mega 2 to the SLM804 (unfortunately,
the SLM804 is not in my work area or I would use it instead of the PC/HP
combo). With Ditto II, I could run GEM Draw on my ST and print it to an
SLM804. That way, I could justify getting an SLM804 in my work area (with
Spectre GCR I can print Mac stuff to the SLM804 as well, not to mention
lots of ST code output).

Question: Does Ditto II support the SLM804?????