🚀 go-pugleaf

RetroBBS NetNews Server

Inspired by RockSolid Light RIP Retro Guy

Article View: comp.sys.atari.st
Article #38562

Low cost solution to short cable/noise problems???

#38562
From: John Stanley
Date: Sun, 07 May 1989 04:55
45 lines
2826 bytes
In comp.sys.atari.st, Daniel A. Glasser <dag@per2.UUCP> writes...

> I have a rather old Supra 20 meg drive which contains a 3.5" SCSI
> hard disk, a power supply and a Supra AHDI to SCSI board.  The drive

..etc...etc...etc.. (about short drive cables)

> someone else would have done it a long time ago...  So...  Has anyone
> out there tried this approach?  I'd rather not set off on a course
> which may damage my system without checking around first to see if it
> is a valid one.

  The ICD host adaptor I'm using is in a small box (1" x 4" x 6") with a
cable coming out both ends.  One cable goes to my ST and is about 2ft
long.  The other, which runs to a harddisk drive-box with a power supply,
is about 6ft long (but I could have ordered it in a longer length).  The
power for the adaptor comes thru the cable from the power supply in the
drive-box so I only needed one extra outlet and it didn't need to be
right next to the ST.

  I'm very happy with this new setup.  I can put my drives anywhere
within 7 feet of my ST which gives me plenty of places where it's out of
the way, off my small compuer desk, and someplace where the noise isn't
as obvious.

  Cautionary Note:  I got this setup from Tech-Specialities.  I have no
idea if this is the standard configuration if you buy directly thru ICD.
I've inspected the hardware and it's superb, but when I ordered the hard
disk and host adaptor I made it clear that I needed it asap.  They agreed
to get it to me in 6 weeks.  I can't fault their workmanship, but I can't
recommend them to everyone because they were 4 weeks late with delivery,
gave excuse after excuse for the delays, and when I returned the drive
mechinism (NOT a problem with their hardware) for repair (next day UPS)
they took over a week before they even opened the box (I called and
asked...).

  I've heard similar stories from other people who have delt with them.
(ie. They're slower than frozen molasses, but their prices are good and so
is their hardware.) -Only- order from them if you're willing to -wait- (and
wait, and wait, and...).  Also be warned that they delay (at least) 10 days
for personal checks to clear and they don't accept credit card orders...

---
John Stanley <dynasoft!john@stag.UUCP>
Software Consultant / Dynasoft Systems
Technical Details
Message-ID: <0406892355260743@dynasoft.UUCP>
Path: arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!csd4.milw.wisc.edu!indri!nic.MR.NET!shamash!com50!pwcs!stag!dynasoft!john

Show Full Headers
Complete Article Headers
Path: arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!csd4.milw.wisc.edu!indri!nic.MR.NET!shamash!com50!pwcs!stag!dynasoft!john
From: dynasoft!john@stag.UUCP (John Stanley)
Newsgroups: comp.sys.atari.st
Subject: Low cost solution to short cable/noise problems???
Message-ID: <0406892355260743@dynasoft.UUCP>
Date: 7 May 89 04:55:26 GMT
Reply-To: dynasoft!john@stag.UUCP (John Stanley)
Organization: DynaSoft Systems, Minneapolis, MN.
Lines: 45
X-Member-Of: STdNET (ST Developer's Network)