🚀 go-pugleaf

In article <90030820221525@masnet.uucp> calvin.bruner@canremote.uucp (CALVIN BRUNER) writes:
>If anybody can help, I would appreciate it!  I'm running into so many
>problems on what should be a simplistic matter, I can't believe it!
>  1) I used DLII and screwed up a partition of my hard drive
>  2) I zeroed the partition, and eventually reformatted the drive in
>     order to restore it from backup.
>  3) The problem seems to be that when I transfer 172K or larger
>     programs, The drive freezes with busy light on and system says
>     drive is not on or not plugged in properly etc.
Sounds like you have a hardware problem. (Software should not wear out
like this.)
This value of 172K is intriguing. This might be caused by a memory 
problem, therefore run a memory test program. Also, open your computer
and re-seat all socketed chips. This seems to work for many people.

Can you cause your computer to fail by dropping it from 1 inch on a
table ?  This would indicate bad connectors or sockets.

Of course, the problem could also be in your hard drive. DON'T test
it for bad connectors by dropping! (More general: never move a running
hard disk drive.) Instead, borrow another ST and try to restore your
files with that machine. If it fails in a similar way, your drive,
drive controller, drive power supply, or cable is bad.
-- 
  _____       __  __  __  __   ____   _____   _____   ______  _____    _____ 
 |  _  \     |  |/  ||  \|  | /    \ |  _  \ |  _  \ |   ___||  _  \  /  ___|
 |   __/ _   |     < |      ||  ||  ||   __/ |   __/ |   >__ |     <  \__  \
 |__|   |_|  |__|\__||__|\__| \____/ |__|    |__|    |______||__|\__||_____/
P. Knoppers, Delft Univ. of Technology, The Netherlands, knop@duteca.tudelft.nl