🚀 go-pugleaf

JJL101@PSUVM.BITNET (J.J. Lehett) writes:


>    I know this may be an old topic....but I really would like to stop having
>to drop my ST before I boot it to work properly  :)  I know its a looses
>chip problem (at least pretty sure it is), but don't know which it is.

In my 1040 it was the memory controller. The ST was sensitive to the slightest
tremor, so I opened it up, and touched the ICs. I took out the culprit, cleaned
it by scratching the contacts of the IC and the socket, and put it back together.
Everything works fine. One warning: visit an electronics store first, and get
a anti-static wrist band to connect yourself to the Atari PC board. CMOS is
not as sensitive as a few years back, but those Atari ICs are expensive.

Opening the ST was not very problematic, I only needed pliers and a set of
screwdrivers. Be careful when you take these LLC ICs from their sockets.

Ge' Weijers
Ge' Weijers                                    Internet/UUCP: ge@cs.kun.nl
Faculty of Mathematics and Computer Science,   (uunet.uu.net!cs.kun.nl!ge)
University of Nijmegen, Toernooiveld 1         
6525 ED Nijmegen, the Netherlands              tel. +3180612483 (UTC-2)