🚀 go-pugleaf

I have just down loaded Uniterm 2.0e from Terminator. When I tried it
from home last night, I ran into a problem. The dialing would get locked
into dialing one number if there was anything wrong with the dialup. For
example, if the number I was dialing was busy, then the modem would report
it and any keypress in Uniterm would cause an automatic redial of the number.
Also when the connection was made, all I got was garbage on the screen as if
I was using the wrong baud rate. After hanging up and trying to dial another
number, Uniterm would instead dial the previous number. The [control] C
did not get me out of dialing mode. Nothing would work and I would have to
reboot the computer. Can anyone tell me what I am doing wrong. The setup of
the terminal is the same that works in my previous terminal program. My setup
is a 1040ST, TOS 1.4, TurboST 1.6, Multidesk, Cache090, Maccel2, G+PLus, and
Megadisk as a 1Meg RamDisk.

Thanx in advance.



-- 
Aaron the Alchemist
Charlop@uwchem.chem.washington.edu