🚀 go-pugleaf

In article <24494@cup.portal.com> Bob_BobR_Retelle@cup.portal.com writes:
>j.harris asks, about the DataFree memory upgrade board:
>As for the problems locating the proper resistors to lift, I'm afraid I
>can't offer any help.  I don't remember seeing a Revision C board.  I know
>it's a long, long distance call, but it might be best to call DataFree and
>see what they say about it...

Probably, You are searching for the resistors to remove to disable half
of the on board RAM.
You have to remove just one resistor, the one in the RAS line (without
RAS a RAM will stay in Tristate forever).
RAS is pin 4 (four) of the 41 256 chips on the board and pin 3 (three)
of the megabit chips.
The RAS of the 256 chips must be disconnected from the MCU to disable
them.

hase
-- 
Hartmut Semken, Lupsteiner Weg 67, 1000 Berlin 37 hase@netmbx.UUCP
Dennis had stepped up into the top seat whet its founder had died of a
lethal overdose of brick wall, taken while under the influence of a
Ferrari and a bottle of tequila. (Douglas Adams; the long dark teatime...)