Re: Net/Comm Wishlist (was SVR4 Transport Layer Interface)

Thread View: comp.sys.concurrent

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Kenneth H. Jacker Wed, 22 May 1991 05:53

#104

Author: Kenneth H. Jacker
Date: Wed, 22 May 1991 05:53

34 lines
1770 bytes

In <5464@gazette.bcm.tmc.edu> simon@fuquad.westford.ccur.com
(Simon Rosenthal) writes:

>TLI will be supported in RTU 6.0 

>The Networking/Communications group would really like to hear your
>wishlists - the reality is that there are far more networking 
>standards out there than we can realistically support, so we have to
>prioritize. Knowing our customers' requirements and wishlists helps a lot. 
>
>				Simon Rosenthal
>				Networking/Communications Group.

I'd like to request the addition of "rexecd".

I access our 6450 using MacX.  It uses "rexec" to run commands on
remote hosts.

Since the current version of RTU doesn't support "rexecd", I must first
"telnet" to the Concurrent system, set DISPLAY, start an "xcterm" session
(or whatever) back to my Mac, and finally terminate the "telnet" session.

I'd much prefer to have MacX directly initiate a new client.

-------
Kenneth H. Jacker            Domain:   khj@ms.appstate.edu
Dept of Math Sciences                  khj@ecsvax.uncecs.edu
Appalachian State Univ
Boone, NC  28608             BITNET:   khj@appstate

Articles to: concurrent@soma.bcm.tmc.edu or uunet!soma.bcm.tmc.edu!concurrent
Administrative stuff: concurrent-request@soma.bcm.tmc.edu
Stan Barber, Moderator

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads