🚀 go-pugleaf

In article <0093D4F7.E4C82900@BINAH.CC.BRANDEIS.EDU> tmiller@BINAH.CC.BRANDEIS.EDU writes:
>Hello,
>   I'm having a problem with installing a ST251-1 (40mb) disk drive on
>my PRO running POS 3.2 .  I wonder if anyone else has ever done this.
>While it works fine as a second drive if formated from the toolkit if
>I try and install POS on it it returns a FBI (format/bad block/initialization)
>error during the install.  I theorize that there is an error block which
>is bad in the boot sector and that the PRO can't re-vector the boot sector
>but there is a specific error for that condition and further investigation
>of the error dump status tells me that there was an 'unrecoverable error'
>rather than a 'bad block in boot sector'.   
>	Any ideas?
>

Are you using the proper controller card for that drive?  When I upgraded 
from a 5 Mb drive to a 20 Mb drive on my Pro I had to get a new controller
card because I was told that all the controller cards were limited as to
what size hard drives they could handle.  Another question that comes to
mind is if you have lots of time you could install the drive into an MSDOS
computer temporarily.  There are tons of MSDOS HD diagnostic programs around
which could tell the status of the boot sector on your ST251.




--
Chaim Dworkin                             (chaim@eniac.seas.upenn.edu)