🚀 go-pugleaf

I've been round & round & round with my vendor.  No luck getting the RZ57 on a
controller and working.  The RZ57 works fine when I connect it to a DECsystem
3100, so it's probably not a problem with the RZ57 (DEC-labelled Micropolis, I
believe).

The controller card they (Digital Basics) have been pushing is the CMD
Technology CMD220/TM (dual disk/tape controller).  The second I put it in the
5400, the green LED (all OK) and the red LED (not all OK) both light up and
Ultrix does not see the controller when identifying controllers and devices at
boot time.

Right now I'm just about desperate enough to go with anything that works.  I've
got the controller to be recognized by Ultrix 3.0 on a VAXstation 3200 (the
controller shows up as an MSCP device), but any references to the disk just
hang and sit there.  Maybe there's something that needs to be switched on the
RZ57 to get it working with something other than DECsystem 3100.

Anybody have any _WORKING_ solutions to this problem of attaching an RZ57 to a
5400?  Lots of brownie points awarded for any working solutions.  I'll even
give out brownie points for untested solutions.

On a related theme, anybody know of _WORKING_ 4mm tape solutions for the 5400?
If not, what's your favorite 8mm solution?

I'm running Ultrix 3.1C.

Thanks,
Stefan Brandle
-- 
---------------------------------------------- MA Bell: (708) 260-4110 ---------
Stefan Brandle                  UUCP: ...!{obdient,uunet!tellab5}!wheaton!stefan
Wheaton College			or	stefan@wheaton.UUCP
Wheaton, IL 60187 		"But I never claimed to be sane!"