🚀 go-pugleaf

In article <1991Jun18.060340.12977@uokmax.ecn.uoknor.edu> sspatter@uokmax.ecn.uoknor.edu (Samuel S Patterson) writes:
>Here I go wasting bandwidth again...  
>Okay, here we go...
>---------------------------------------------------------------------------
Here we go, indeed.  Second column is old DEC product lines,
	peripherals, PDP8, PDP11, catalog

G050	periph	9-track 45ips dual gap head read amp
G060	periph	mag tape compressor, 9 track
G062	periph	mag tape peak detector, 9 track
G064	periph	mag tape slicer, 9 track
G350	periph	9 track, dual head, 45ips mag tape write driver
G727	11	bus-grant jumper
G741	periph	18 5-ma neg. clamp loads for TU10-E, -F
G932	periph	capstan servo preamp
G933	periph	reel motor amp for TU10 +-12v +-6a
G934	periph	brake actuator for TU10, 6v, initially 0.8a, finally 0.1a
G9340	periph	replacement for logic portion of G934
G9341	periph	replacement for output portion of G934
M050	cat	inverting driver, 12 ckts, -30v 50 ma
M100	8	neg bus, 15 input ckts, 1 common and 1 independent gate
M105	11	device selector for PDP11
M302	cat	2 one-shots
M454	11	crystal clock for DC11-A, DP11-A
		 outputs 28.8, 19.2, 9.6, 4.8, 2.4, 1.76, 2.152 kHz
M4540	11	M454 w. more frequencies available
M5904	11	massbus control transceiver
M7065	11	synch. line receiver, 6, 7, or 8 bits
M7075	11	synch. line transmitter, 6, 7, or 8 bits
M7212	11	address line bus repeater for DB11, 10 ch
M7294	11	data buffer & cont., RH11
M7295	11	bus control, RH11
M7296	11	control & status registers, RH11
M7297	11	massbus parity control, RH11
M763	periph	9-track write buffer for TU10
M765	periph	9-track read buffer for TU10
M767	periph	clock & skew delay logic for TU10
M7671	periph	master/slave bus driver for TU10 masters, 25 ckts
M7673	periph	TU10 data checker
M768	periph	delay selector for TU10
M7735	cat	module LAXX-KV formfeed option for LA36
M7819	11	8-line async terminal mux DZ11
M7820	11	interrupt control (7-bit vector) 1 per PDP11 peripheral
M7821	11	fast m7820
M783	11	12 bus drivers, PDP11
M784	11	16 unibus receivers, PDP11
M785	11	16 unibus transreceivers, PDP11
M7850	11	memory parity (11/40, 11/34)
M7856	11	DL11-W serial line unit
M7859	11	programmer's console
M7891	11	MOS memory (size unknown, count the chips)
M7900	11	unibus interface RK611
M7901	11	register board RK611
M7902	11	control RK611
M7904	11	drive interface RK611
M7911	11	tape control TMB11
M7912	11	TMB11 module
M795	11	DMA word count & memory address
M796	11	unibus master control (DMA)
M8265	11	data paths (11/34)
M8266	11	control (11/34)
M890	periph	motion control for TU10
M891	periph	crc & write gating for TU10
M892	periph	gap timing & read parity for TU10
M895	periph	read & write timing for TU10
M920	11	bus jumper
M9202	11	bus jumper (with 2-ft folded unibus cable inside)
M930	11	bus terminator
M9300	11	bus terminator with nonexistent NPR device detector
M9312	11	bus terminator & boot ROM
M954
M981	11	bus jumper with terminators (PDP-11/40)
P17
W726	periph	4 dc & 3 differentiating switch filters for TU10
>--------------------------------------------------------------------------
>And probably a few others in the boxes I haven't unpacked yet.  Any info
>on them would be really appreciated...

It's been a real nostalgia trip.

-- 
        carl lowenstein         marine physical lab     u.c. san diego
        {decvax|ucbvax} !ucsd!mpl!cdl                 cdl@mpl.ucsd.edu
                                                  clowenstein@ucsd.edu