MicroVax III

Article View: comp.sys.dec

Article #5402

#5402

From: Richard L Watterson
Date: Wed, 31 May 1989 18:20

22 lines
1581 bytes

I have a MicroVax III (3200) on which I am trying to get Mt Xinu's
more release of 4.3 BSD running.  The problem is that when I run the
makelabel program everything seems to be ok.  However, when I try to 
boot it dies complaining about executing a halt instruction.  We are
using an Emulex QD33 disk controller with a CDC 9766 disk drive.  The
QD33 is supposed to act like it is connected to a RA81 disk.  We currently
have Ultrix running since we did not get a boot tape with the More
release.  At first we were just going to use the ultrix boot stuff,
but it turns out that Mt. Xinu leaves a hole in the middle of their boot
program in which they place their disk label.  The ultrix boot code does
not have a similar setup, so copying the ultrix boot program onto disk
wipes out the Mt Xinu disk label.  Has anyone out there successfully
installed Mt Xinu 4.3 on a MicroVax 3200?  If you have any ideas please
respond to me directly.
Richard


---------------------------------------------------------------------
Richard Watterson				rlw@cs.purdue.edu
Department of Computer Science			{backbone}!purdue!rlw
Purdue University
West Lafayette IN

Technical Details

Message-ID: <6845@medusa.cs.purdue.edu>

Path: arc1-ca.pugleaf.net!utzoo!attcan!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!purdue!rlw

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!attcan!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!purdue!rlw
From: rlw@cs.purdue.EDU (Richard L Watterson)
Newsgroups: comp.sys.dec
Subject: MicroVax III
Keywords: Can't boot Mt Xinu 4.3 more release
Message-ID: <6845@medusa.cs.purdue.edu>
Date: 31 May 89 18:20:09 GMT
Sender: news@cs.purdue.EDU
Organization: Department of Computer Science, Purdue University
Lines: 22