🚀 go-pugleaf

In article <8563@batcomputer.tn.cornell.edu| hurf@tcgould.tn.cornell.edu (Hurf Sheldon) writes:
|
|	uVaxen running Ultrix3.1 (we hope)
|	We are trying to upgrade our uVaxII system with a new processor
|	from a vaxstation3200 - everthing has been good until we tried
|	to boot the kernal with the dhv11's called 'dmz0, dmz1' in the
|	config file - fails with the error :
|	'Warning: DMZ Master Clear failure, octet 0
|
|	then 'panic segmentation fault' with trap and stack dump
|
|	Any light on the matter would be a boon
|
|	The installation kernal booted, ran the installation, configured
|	the kernal with the dhv's as 'dmz's, built the kernal without
|	complaint but the kernal crashes as described above.

Why did you configure your DHV11's as DMZ's?  Check the manual
again and try using the following:


device         dhu0      at  uba0      csr 0160500   flags 0xffff   vector dhurint  dhuxint  
device         dhu1      at  uba0      csr 0160520   flags 0xfff3   vector dhurint  dhuxint  


Be sure to check what the csr's should be set to for your machine.  Your
flags will also probably vary.
-- 
Dave White	Grass Valley Group, Inc.   VOICE: +1 916.478.3052
P.O. Box 1114  	Grass Valley, CA  95945    FAX: +1 916.478.3887
Internet: davew@gvgpsa.gvg.tek.com     UUCP:  ...!tektronix!gvgpsa!davew