🚀 go-pugleaf

In article <1787@bucket.UUCP> jimw@bucket.UUCP (Jim Willing) writes:
> Having one heck of a time trying to set up some drives on a Vax 750 with
> am Emulex SC750 emulating SMD controller.
> 
> Installing it was straight forward enough, but we did not get cables with
> the board.  Did not seem much of a problem as SMD cables are standard enough
> but I come to find that Emulex splits the 60 pin 'A' cable off into a 34 pin
> and 26 pin connector where it connects to their 'paddle board'.
> 
> So... we tried the obvious.  Run lines 1-36 to the first connector, and lines
> 37-60 to the second connector.  Seemed reasonable, but it don't seem to work.

The second connector plugs in "backwards" from the first one or some similar
confusion.  That is, if you wire it up the obvious way, when you plug in the
second, smaller connector you want to ignore the pin 1 indication and plug it
in upside-down. I suffered extreme pain from this a couple years ago, but had
almost mangaged to repress the entire incident...

-- 
George Robbins - now working for,	uucp: {uunet|pyramid|rutgers}!cbmvax!grr
but no way officially representing	arpa: cbmvax!grr@uunet.uu.net
Commodore, Engineering Department	fone: 215-431-9255 (only by moonlite)