🚀 go-pugleaf

Hi,

In order to run the console, check out the PTF's that do exist for it.
Having a blank screen is a typical case of a mismatch between the AS/400 and
the console.  Both should be at the same version which is 3.52 at this time
(have seen similar experiences however by using the WAS Adv on the PC, and
SE on AS/400).

As far as running the samples is concerned... is WAS enable on port 8000 ?
In the HTTP config you should have several lines to support WAS calls from
the HTTP server.  In addition, the virtual host definition needs to included
the port 8000 URL as well (which it doesn't by default... only port 80).

With some pain I got WAS 3.5(2) running fine on our AS/400.  The console is
however very slow, but luckily the performance of WAS itself running
servlets and JSP is quite good.  Keep in mind that minimum memory
requirements for WAS are at least 1GB !

Kind regards,
Paul
-----------------

chai hua wrote in message ...
hi , here .

it take me 2 week to order websphere 3.5 for AS/400 , PTFs , JDK 1.2 ......
now , the QEJBSBS is start up normally, and I'm sure I have watched the
message form QEJBADMIN's joblog , it like this "WebSphere administration
server QEJBADMIN ready." following IBM's guide , it means I have install
webshere successfully . you know it is a good news .

but now , I try to run a very simple test , "Hello World" , you know it is
very easy to call it when i use websphere 2.02 (5769-AS1)  , just like
this in my browser , "http://myas400:8000/servlet/HelloWorldServlet"
but after i try run the same call in our new environment ( that i installed
webshere 3.5) . i meet a error message ,"403 , you have not authrity ...."

i have to look up IBM's installation guide . interesting ! now , IBM said
try this test call , http://myas400:8000/servlet/hello .
yes sir ,IBM , i do following your guide . but i also meet the same error
message .

By the way , i also meet other "azaming" thing . IBM's Guide said . i have
to install a Websphere Console , okey , i do . you are IBM , you are always
right , i do , i do .

i install websphere console in my NT server .( following what IBM said) .
but , after installation . i locate the address to my AS/400 . the console
is runing . then i get a windows in my screen . but , everything in this
windows
is dead . i can't do nonthing ???!!!

okey , that is all . is my story about insatll webshere 3.5 for AS/400 .

here , i really want to know , anybody have a successful experience for do
that ?
please help me . my boss has show me a drity face . of course i think ,
should
he show it to IBM .

chai hua







       The contents of this message express only the sender's opinion.
       This message does not necessarily reflect the policy or views of
       my employer, Merck & Co., Inc.  All responsibility for the statements
       made in this Usenet posting resides solely and completely with the
       sender.