🚀 go-pugleaf

I boot from SCSI CD's or CDR's or CDRW's but this is done by setting the 
BIOS on the SCSI card to boot the device.
The SCSI setting on the motherboard only allows a SCSI card with a bootable 
BIOS to boot first rather than the onboard IDE controller.
Some motherboards allow there version of a SCSI card to be added.
Unless you have a suitable card with a boot BIOS eg Adaptec 2940
(AU,UW,W2W), motherboard manufacturers SCSI card, etc then forget it.
If you card is a AHA1505/1515, etc they DON'T boot - as they don't have a 
bootable BIOS.


If you have a Adaptec 2940(as above) you can boot Windows 98/NT4/2000 and 
install it from the CDROM - no floppy required.
Even motherboards that supposedly support booting from an IDE/ATAPI Cdrom 
do not boot Windows 98/NT4/2000 because they don't support Microsofts EL-
Torito protocol.

It can all be confusing at times but remember this -
The wonderful thing about standards - is that there are so many of them.

Regards,
Nick





chico_bento@hotmail.com (Scott) wrote in 
<o22j4sgrbov3vqgstk93vb24v27vugovst@4ax.com>:

>Should I be able to BOOT from my SCSI CD Burner?  My BIOS includes the
>following option in the Boot Sequence
>
>CDROM,C,A     - is this limited to IDE CD-ROMs?
>SCSI,C,A     - is this limited to SCSI Hard drives?
>
>
>Do I need to set a particular device number?
>Can you boot at all from a SCSI hard drive?
>
>I am about to put in a real SCSI card and a second CD-R (reader).
>Will I have any hope with the second Reader?
>
>
>Motherboard:     Gigabyte GA-586TX3
>BIOS:          Award.  Version I'd need to reboot...
>CD-R:          Matsushita CD-R CW-7502
>SCSI card:     Adaptec (single device card packaged with CD-R)
>
>Thanks
>
>Scott
>
>chico_bento@hotmail.com
>
>Could you CC and email to my for replies posted to the group?  Thanks
>
>