🚀 go-pugleaf

Martin Berry <martin@lanch.demon.co.uk> wrote:
>In article <31069643.3913510@news.innotts.co.uk>, Eddy Hood
><eddy@innotts.co.uk> writes
>>Martin Berry <martin@lanch.demon.co.uk> wrote:

>>>Aztech CDA268-03I EIDE cd-rom using the interface on a Multimedia Pro
>>>16AB Version 2.01 soundcard (don't know the maker). The device driver is
>>>sgide268.sys. The machine is a P66 supplied in the UK by Escom.

>>in config.sys:
>>device=c:\blah\blah\sgide268.sys /d:MSCD000
>>
>>in autoexec.bat:
>>c:\blah\blah\mscdex /d:MSCD000

>Yes that is what I meant. Those were the settings I tried but I got an
>error message saying that it couldn't find the cd drive. I assume that
>it requires other settings to be defined. I also tried the /L: switch to
>tell it which drive letter to assign. Escom helpline isn't much help
>either.

I think I've seen this on a friend's Escom - the configuration for the 
sound card (including the IDE settings for the CD) were supplied as a 
parameter to the sound card device driver loaded in config.sys IIRC - 
a switch followed by some hex chars, the format of which wasn't 
obvious - you need to (get hold of and) run the sound card setup disk.

(That was the conclusion I came to after trying to check the IRQ 
settings on it - the setup s/w wouldn't display the current parameters 
- only allow you to assign new ones...)

HTH,

Graham.
-- 
----[ Graham E. Kinns ]----==========----< Graham@grempc.demon.co.uk >----