🚀 go-pugleaf

In article <48hml5$6sh@peavax.eng.pko.dec.com>, Dave Tatosian
<tatosian@plough.enet.dec.com> writes
>In article <344074792wnr@jfinl.demon.co.uk>,
>   Joseph Finlay <Joseph@jfinl.demon.co.uk> wrote:
>>Can Bios parameters be printed from screen to printer?
>>
>>Print Scrn key does not work until boot up is complete. There must be an 
>>easier way than writing everthing down in long hand. This is seriously 
>>pissing me off!!! 
>
>Assuming you have the "right" type of printer and it's hooked to LPT1:, if the 
>Print Screen doesn't work while you're in the cmos setup, I'd guess your bios 
>is indeed the limiting factor (Bad Bios! Bad BAD Bios!)...
>
I seem to remember reading that the printing routine may not be
initialised until after it's too late to go into Bios setup. However I
think that letting it boot up normally, pressing Ctrl. Alt. Del. and
then going into Bios setup again was supposed to work as the print
routine would already be initialised from the first boot up. 

You've probably already tried that though...
------------------------------------------------------------------------
                            David Reid
                               (o o)
                           ---m--U--m---
                Wot no "Turnpike Evaluation" message?