🚀 go-pugleaf

In article <Dn3JI4.3Ax@zadall.com>, duane@zadall.com says...
>
>Hi,
>
>   I just got a Practical Peripheral 28800 PM288MT II v.34 modem. I'm trying 
>to set it up but I'm having problems. According to the manual, I should be 
>able to do a AT&f1 to set it up for the standard PC defaults. Each time I do 
>this however I get an ERROR back not OK. This is the same for the other 
>factory defaults except for 0. Digging a bit further I found that ati3 should 
>return the firmware version in the format of:
>
>   PM288MT II V.34 Rev. x.xx.
>
>However, what I see is 
>
>04-00971-710 34AC
>
>ATi6 (session stats) is another command which returns an ERROR.
>
>I have a PPI 14400 which works correctly with the above commands. Has anyone 
>seen this with a PM288MT modem? Do I have a modem which the incorrect 
>firmware? I have got the modem working using the string AT&f&c1&d2&k3 but it 
>seems strange if I'm missing some commands.
>
>Thanks,
>
>   Duane
>--
> +-----------+-------------------------------------------------------------+
> | ********* |   Duane Hargrave               Internet: duane@zadall.com   |
> | **   ***  |                                            djh@wimsey.com   |
> |    ***    |   Zadall Systems Group, A division of NDC                   |
> |  ***   ** |   4400 Dominion Street, 5th Floor Voice: (604) 436-0033x650 |
> | ********* |   Burnaby, BC, Canada V5G 4G3       Fax: (604) 436-5711     |
> +-----------+-------------------------------------------------------------+


I remember seeing a post very recently (maybe on compuserve) from a PPI tech saying that the 
"f1" has been replaced by "f" in the
new ppi288 modems, so I'm almost 100% sure you're OK with the the &f in there. 

JK